Encyclopedia > Dynamic Mechanical Spectroscopy

  Article Content

Dynamic Mechanical Spectroscopy

In this technique a material (usually a slab of polymer) is exposed to a periodical deformation. The deformation can be in tensile, compression or bending mode but torsional deformations are the most practical ones because they tend to produce a linear response more readily. In other words the deformation (strain) can be described a linear function of the appied force (stress). The coefficient that links the two is called the modulus:

   Strain = modulus * stress

In DMS the modulus is measured as a function of the frequency of the deformation and/or the temperature of the experiment. Because the temperature is typically varied in a systematic way the technique is also known as Dynamic Mechanical Thermal Analysis. (DMTA)

The modulus is generally a complex number, because when the applied stress is sinusoidal (i.e. a single frequency is applied) the strain can lag behind in time. The phase shift is due to viscous as opposed to elastic effects.

When the material undergoes a glass transition[?] these losses reach a maximum. The temperature at which this happens, however, is frequency dependent.

The mechanical excitation does not have to be a single sine wave, in fact more than one frequency response can be measured simultaneously in a process called multiplexing. Often a block wave is used rather than a sine wave. This is an application of the Fourier transform principle. A requirement for its application is that the response is linear for all frequencies.



All Wikipedia text is available under the terms of the GNU Free Documentation License

 
  Search Encyclopedia

Search over one million articles, find something about almost anything!
 
 
  
  Featured Article
Fibre optic gyroscope

... dumped 2003-03-17 with ...

 
 
 
This page was created in 21.8 ms